|
|
New Large 1/8 Scale Truggy Filter with 90° Base
|
|
|
Part No. 151691 |
THE NEW OUTER SCREEN AND LARGER SURFACE AREA
ALLOWS FOR MUCH
LONGER RUN TIMES BETWEEN CLEANINGS,
EXTENDING THE LIFE OF THE FOAM.
|
|
New 1/8 Scale Truggy air filter was completely redesigned. We increased the surface
area as much as possible to still be able to fit under
most truggy bodies, allowing for even better breathing and less clogging. This nitro RC air filter has a very
fine micron opening that keeps out dirt better than
ever before. Our plastic is specially formulated
exclusively for Motor Saver air filters for extreme lightness.
|
Part No. 151691
The outer screen dramatically cuts down dirt penetration into inner foam, which increases the life of the foam between cleanings. Inside foam comes pre-oiled. Foam can quickly be removed and easily cleaned.
|
|
Outside screen has a new tighter micron opening that repels more dirt than previous models. The screen is also designed not to absorb moisture.
|
 |
Inside oiled foam has seals around rim top and bottom and through center hole for tight seals from any dirt penetration. |
Outer foam will not get as dirty as quick. |
|
|
This RC air filter is sold with one body clip and can accept two body clips for bracketing: one to hold bracket on; and, one to hold the filter tightly together. This RC air cleaner fits most 1/8 scale truggies and trucks using 90° rubber base. Bracketry from body to air filter may vary. A bracket kit for you to customize to your truggy is available upon request at no additional charge. | |
The screen eliminates the need for outside foam. Putting the outside foam to the inside greatly increases the length of time between cleanings. Instead of outside foam that has a tendency to leek around the outside edges, the foam is encapsulated in a tight sealed screen allowing for better sealing. |
|
|
The foam element is economical and comes in packs of 2 and 6 un-oiled or pre-oiled. Elements have a large center hole, which fit other 1/8 scale nitro RC air filters with large center holes. |
Pack of 2........ Part No. 8FM2 |
|
|
Pack of 6........ Part No. 8FM6 |
|
|
|
|
|
The Outer Saver is designed for additional protection of the Motor Saver filter. The Outer Saver can be easily removed without removing the filter. This makes it very convenient for fast cleanup and reinstallation.
The Outer Saver screen is the same screen used on 'Large' Motor Saver models that repels water, dirt and fine dust. |
|
| |
       
Click on image to enlarge
|
New Large 1/8 Scale Truggy Filter with Long Cap Part No. 15169L |
|
$24.95 |
|
|
|
Copyright © 2024 Motor Saver Filters, Inc. |
|
