|
| New Large 1/8 Scale Off-Road Truck Filter , 151661 |
|
 |
Part No. 151661 |
THE NEW OUTER SCREEN AND LARGER SURFACE AREA
ALLOWS FOR MUCH LONGER RUN TIMES BETWEEN CLEANINGS, EXTENDING THE LIFE OF THE FOAM.
|
Part No. 151661
|
|
New 1/8 scale RC truck air filter was completely redesigned. We increased the surface area as much as possible allowing for even better breathing and less clogging. This nitro RC air filter has a new very fine micron opening that keeps out dirt better than ever before. Our plastic is specially formulated exclusively for Motor Saver air filters for extreme lightness.
|
The outer screen dramatically cuts down dirt penetration into inner foam which increases the life of the foam between cleanings.
This RC air filter is sold with the small neck end cap. An extended cap is sold separately if needed for longer reach. Inside foam comes pre-oiled. Foam can quickly be removed and easily cleaned.
|
This RC air filter does not fit T-Maxx or Revo. Click one for details.
|
|
|
|
|
This RC air filter is sold with one body clip and can accept two body clips for bracketing: one to hold bracket on and one to hold the air filter tightly together. A bracket kit to customize to your truck is available upon request at no additional charge. |
|
|
Outside screen has a new tighter micron opening that repels more dirt than previous models. The screen is also designed not to absorb moisture.
|
 |
Inside oiled foam has seals around rim top and bottom and through center hole for tight seals from any dirt penetration. |
| Outer foam will not get as dirty as quick. |
|
The foam element is economical and comes in packs of 2 and 6 un-oiled or pre-oiled. Elements have a large center hole, which fit other 1/8 scale nitro RC air filters with large center holes. |
Pack of 2........ Part No. 8FM2 |
|
|
Pack of 6........ Part No. 8FM6 |
|
|
|
|
|
The Outer Saver is designed for additional protection of the Motor Saver filter. The Outer Saver can be easily removed without removing the filter. This makes it very convenient for fast cleanup and reinstallation.
The Outer Saver screen is the same screen used on 'Large' Motor Saver models that repels water, dirt and fine dust. |
|
Base Kit Assortment for 15-16mm carbs
Part No. BS1516
Fits new and previous 1/8 scale off-road RC air filters. |
Shown left to right: |
- 90° base, fits most 1/8 carbs
- 60° base, fits 2.5 / 3.3 Revo, T-maxx and most truck carbs
- 60° base, fits HPI truck carb
|
|
An extended cap is sold separately if needed for longer reach.
Extended cap ........................... Part No. 8XCP
Regular cap (replacement) ..... Part No. 8RCP
|
|
|
Copyright © 2024 Motor Saver Filters, Inc. |
|
