1/8 -1/10 Scale On-Road Air Filter
for 15mm-16mm Carburetors
Part No. 1516ST comes with one 15mm and one 16mm straight base.
![](images/1516st_200.jpg)
Straight Base RC Air Filter for JATO 2.5 / 3.3 Part No. JTST
![](images/jtst1.jpg)
Part No. JTST comes with a 16mm base. Shown below with optional spring clamp.
![](images/jtst2.jpg)
This RC air filter has been winning races all over the world for five years. RC racers like it for its very fine dirt stopping power. After a full weekend running, this RC air filter passes the
Q-tip test (run a Q-tip around the inside of the carb) with not a speck of dirt entering the engine.
Motor Saver had phone conversation with Steve Canadian, highly respected on-road 1/8 scale two wheel and four wheel drive RC racer:
"I have been using foam filters on my engines for a long time. I had always gotten some scoring of the piston and sleeve and thought it was normal. I started using Motor Saver Air Filters on some of my engines about two years ago. After inspecting the engines I found the scoring of the piston and sleeve had gone away. This is obviously good for engine life and can relate to other things...to improve racing". |